Recent content by Elysium

It doesn’t unlock Sport Plus or Individual drive mode but outside of that, it is absolutely plug and play for switching between the drive modes that you have. It’s a little tricky to see from pictures but the ‘Sport Plus’ and ‘Individual’ options are visible but slightly greyed out and not...

I tried that with no luck unfortunately. Changed 8LA -> 8LH followed by an autocode.

Just to echo this.. The knob can be found for around $120 on ebay but the trim needed for this is closer to $300. I opted to buy a replacement wheel from ebay for around the same price as I would've paid for the parts. The knob works without any coding. With that said, I have been tinkering...

Just wanted to add some more context to this since I was recently looking through this section. MU_TI_001010 >> Control unit, coding >> powermanagement_timer: t_mmi_off_1: 30 seconds MU_TI_001010 >> Control unit, coding >> powermanagement_timer: t_mmi_off_2: 60 seconds MU_TI_001010 >> Control...

This post indicates the sensor layout a little better. The hardware chart from this post also seems to indicate that exit warning is possible in any vehicle with LCA and doesn't require the ultrasonic sensors as described in the aforementioned post? I have option code 7X2 for Front/Rear...

MRR_HR (Radar HR) -> Rear Radar S1 (Lane Assist Right) Kodierwert: Bitfield Rear_Cross_Traffic_Alert : with_RCTA MRR_HL (Radar HL) -> Rear Radar S2 (Lane Assist Left) Kodierwert: Bitfield Rear_Cross_Traffic_Alert : with_RCTA ZFAS (Zentrales Fahrer Assistenz System) -> ZFAS (Assist) Kodierwert...

I don't have any pictures at the moment but this post shows 3D surround view: https://www.taycanforum.com/forum/threads/3d-surround-view-vs-surround-view.14432/post-217619

I'd check out this guide, it is very helpful if you're just getting started. I'm using a PT3G instead of a VAS 6154 clone but the install steps are still the same.

They do not require PPN, just PIWIS 3 with engineering mode.

I don't believe this one has been mentioned yet. If you have surround view but not 3D surround view: ZFAS AU516 003 -> Kodierwert -> Bitfield (5) TV_3D_Presentation Change from "off" to "on"