Obb & CarScanner Pro

[blackvipergts]

I was first searchig in the Forum but I did not find any post related to my isssue.
Once I connect my ODBII Veepeak Elm 327 to my Taycan 4S Cross Tourism J.1 2021 via CarScanner Pro under car profile set to Taycan and BT properly connected [ Mobile phone Samsung Galaxy 25 Ultra] ,on the Taycan dash board is showed a red message for High Tension Voltage ...
On my wife's EV [Subaru Solterra] the App and ODB are working flowess...Any comment or suggestion are welcome,thank

Sponsored

 

[Vercingetorix]

Nothing to worry about. Every scanner I have hooked up does that.

 

[MidwestPCar]

Do people leave their OBD-II connected scanner on? or attach-read-detach?
I got one, did my CarScanner readings, but took it off and wondered if I could just leave it on.

 

[blackvipergts]

Nothing to worry about. Every scanner I have hooked up does that.

Thank very much ,I was a little bit scared

 

[pteron]

It's because the car is assuming you are going to work on it and 800V will kill you very very dead.

ICE vehicles don't have this feature

 

[blackvipergts]

It's because the car is assuming you are going to work on it and 800V will kill you very very dead.

ICE vehicles don't have this feature

Thank very clear now

Sponsored