I added some pics of the 3D model. The button cap (cosmetic piece) snaps into the post I printed, and then the post goes onto the center switch post, with a press-fit design with those ribs. It grips well enough to hold it on but not so strong it will break the post if it gets hit hard (it would just pop off instead of breaking again like the original part).
I'd be happy to make another one, kinda why I posted it. I can only print with PLA where I do it, it should ideally be printed in ASA or nylon but I haven't tried to set that up yet. My plan was that if there was real interest from others I'd set that up.
If you want I could set that up but ship it to me first to verify it works and then forward it to you...
Awesome! Thanks for testing it out!
