whitex
Well-Known Member
- Joined
- Jul 30, 2021
- Threads
- 58
- Messages
- 4,851
- Reaction score
- 3,993
- Location
- WA, USA
- Vehicles
- 2023 Taycan TCT, 2024 Q8 eTron P+
- Thread starter
- #1
In case you are using a Tesla Gen3 Wall Connector for charging your Taycan (with a TeslaTap of converted with a new cable), Tesla quietly released load sharing firmware for that. The wall connector manual has not been updated with this either, but the instructions are at the link below (along with the link to required firmware which you might have to install manually as per the instructions).
https://www.tesla.com/support/gen-3-wall-connector-power-sharing
https://www.tesla.com/support/gen-3-wall-connector-power-sharing
Sponsored