Illuminated sills help needed

[Fantasmos]

Has someone purchased the aluminum or carbon illuminated sills:

https://tequipment-finder.porsche.c...c=product&pr=7CF753F8A462CC39C1258455003E885C

If so, could you share a photo of the cable end on the car’s side? I am trying to figure it out what pin type is necessary to link the plus to the modules. Thanks in advance!

Sponsored

 

[Gachnar]

I've done this install on a Macan, though looking at those instructions it's pretty much the same. It's not a harness you connect to, you run the negative to the appropriate ground point (a cap nut that you remove and slip the connector over) and the positive to the listed pin point. The workshop manual would be useful, though I have yet to find a free one for the Taycan.

 

[Fantasmos]

What’s the connector type on the positive side? Got a photo?

I have attached the manual in my first post.

 

[Gachnar]

That's the instructions for the sills, not the repair manual, which the instructions refer to for wiring. The shop manual has instructions, diagrams, torque specs etc. for the entire car.

The wires basically look like this (though much longer in the kit and not wrapped

 

[Fantasmos]

So, it is number 10. I’ve already got the pins and connector for the other side, just want to prepare everything before I open them. Thank you!

Sponsored