Nine Volt phone charger installation - Frustrating!

[seattlefox]

Well I was trying to install Nine Volt charger to my new Taycan, and I almost gave up at this moment because I couldn't figure out how to remove the front cup holder! I couldn't get to the first clip but in the installation video it seemed so easy! I never thought I was this clumsy (and my wife had always said good words about my ikea furniture assembling skills).

For folks who installed the Nine Volt charger, what's the trick to get the clip off for the front cupholder??

Is there a clip or something I need to push/pull as I lift up the lower left corner?

Also Amazon same-dayed a set of trim removal tool and hopefully that can help..

Sponsored

 

[whitex]

 

[seattlefox]

I was indeed following that, but couldn't figure out how the first cupholder got off. It seems so easy in the video but the lid was super tight...

 

[SECRET]

I held it from inside the cup with my right hand fingers and braced my thumb on the outside then wiggled it up.

 

[seattlefox]

I held it from inside the cup with my right hand fingers and braced my thumb on the outside then wiggled it up.

Thanks! You'll need to get the first bottom-left corner clip off before you can wiggle it right? I was stuck at that step..

 

[seattlefox]

Update: job finished! What saved my clumsy ass was this thing. 10 bucks from Amazon.

Thanks guys!

 

[Watchesandburgers]

Post a pic of the completed job or we won't believe you.

 

[seattlefox]

Post a pic of the completed job or we won't believe you.

Sure boss

This thing is such an elegant solution!

Sponsored