seattlefox
Active Member
![United-States Country flag](https://www.taycanforum.com/forum/misc/flags/shiny/32/United-States.png)
- Thread starter
- #1
Well I was trying to install Nine Volt charger to my new Taycan, and I almost gave up at this moment because I couldn't figure out how to remove the front cup holder! I couldn't get to the first clip but in the installation video it seemed so easy! I never thought I was this clumsy (and my wife had always said good words about my ikea furniture assembling skills). ![Frown :( :(](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
For folks who installed the Nine Volt charger, what's the trick to get the clip off for the front cupholder??
Is there a clip or something I need to push/pull as I lift up the lower left corner?
Also Amazon same-dayed a set of trim removal tool and hopefully that can help..
For folks who installed the Nine Volt charger, what's the trick to get the clip off for the front cupholder??
Is there a clip or something I need to push/pull as I lift up the lower left corner?
Also Amazon same-dayed a set of trim removal tool and hopefully that can help..
Sponsored
Last edited: